Net2phone Max 430 User Manual download pdf (Page 30)

Max 410/420/430 User’s Guide – Chapter 3

addresses, using either a telephone keypad or serial

connection. The process will entail the following steps:

1. Disable DHCP in the Max 410/420/430.

2. Enter a static IP address.

3. Enter a netmask address.

4. Reset the unit.

5. Log in to the Max Web Manager.

6. Set the required configuration parameters in the

Max Web Manager.

Entering Static IP Addresses from a

Telephone Keypad

If your LAN uses static IP addresses, the most practical

way to set up the Max 420 or 430 is to enter an IP address

and netmask from a telephone keypad. You can then

finish setting up the unit while browsing the Max Web

Manager.

Disabling DHCP from a telephone keypad (Max

420/430)

Since the Max 410/420/430 is shipped with DHCP

enabled, you need to disable DHCP to use static IP

addresses. To disable DHCP, proceed as follows:

1. Connect an analog telephone to any RJ-11 port

on the Max 410/420/430.

2. Lift the handset and dial

***5 (the disable DHCP

parameter code).

The voice prompt announces, “DHCP is disabled

now. Please press pound”.

3. Press the pound key (#).

4. Hang up the telephone.

DHCP is now disabled.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 95 96

No comments

Net2phone Max 430 User Manual Page 30